Flow Rate Boundary Condition

Hi,

Apologies if this has been asked, I couldn't find another thread about this. Is there a way to automatically apply flow rate boundary condition? Or do I need to manually calculate the velocity based on flow rate + area of patch and then apply that?

Thank you!

Woven6280 wrote

Apologies if this has been asked, I couldn't find another thread about this. Is there a way to automatically apply flow rate boundary condition? Or do I need to manually calculate the velocity based on flow rate + area of patch and then apply that?

No, at the moment inflow boundary conditions are based on velocity, so to account for a specific flow rate you would manually have to adjust for the boundary area.

Thank you!