Error saving as Model

Previous Topic Next Topic
 
classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

Error saving as Model

randress
This post was updated on .
Using 1.12.2.120, I created this geometry in a new model:



(note: The above screen showing the geometry does not necessarily correspond to the state of FEATool when the following errors appeared)

Upon attempting to save it as a model file I got this error:



I then saved it as a script:

cylinders_between_cylinders.fes

Then started a new model and loaded the saved script.  When the script finished executing, I got this similar but different error:



What might be the problem? What else should I provide to help?

-Randal

Edit:  Just installed 1.12.2.121 and encountered same behavior on saving as model.
Reply | Threaded
Open this post in threaded view
|

Re: Error saving as Model

Precise Simulation
Administrator
Thank you for the issue report, this issue should be fixed in build 20.05.122.
Reply | Threaded
Open this post in threaded view
|

Re: Error saving as Model

randress
Precise Simulation wrote
Thank you for the issue report, this issue should be fixed in build 20.05.122.
Indeed it is...Thank you for fixing it!
Kind regards,
-Randal